Table of Contents
Advertisement
WARNINGS:
- Always consult your employer's rules and procedures to cut rails in the presence of electri-
cal traction return current.
- Follow the precautions described in § 7.1.
- Ensure that everyone keeps the safety distance from the cutting zone.
- Remove aggregate (min. 15 cm) from the cutting area under the rail, to avoid
interference with the cutting disc guard and to make it easier to remove the disc when the
cut is fi nished.
– Fix the arm to the rail at the pre-esta-
blished point (Ref. to § 5.1)
NOTE: Check that the reference plate (5) is
totally turned; during the fi rst cut, the
origins of the cutting distances must be
defi ned exactly (Refer to § 6).
– Mount the rail saw onto the arm (Ref.
to § 5.4).
– Start the engine (Ref. to § 4.4).
– Support the rail saw by holding the upper
handle with one hand and with the other
hand pull out lever (7) locking it in the
external position to release the arm.
– Press the accelerator completely, slowly
bring the cutting disc towards the rail,
whilst respecting the precautions descri-
bed in § 7.1.
19
7
5
Advertisement
Table of Contents
