Software Update; Wireless Connectivity - Bush FVPZAPPER100 Instruction Manual

Advanced features
Getting the most from your set-top-box

Software Update

Your box is capable of finding and updating the firmware
automatically via the broadcast signal or via Internet.
Software upgrade search via user
interface
On the main menu select Settings and then More.
Navigate to Software upgrade and press the OK button.
In Upgrade options menu select Scan for upgrade and
press OK button to check for a new software upgrade.
If a new upgrade is found, it star ts to download
t h e u p grad e. Af te r t h e d own l oad is comp leted
confirm the question asking about rebooting the
box by pressing the OK to continue with the reboot
operation.
3 AM search and upgrade mode
Your box will search for new upgrades at 3:00 o'clock
if Automatic scanning option in the Upgrade options
menu is set to Enabled and if the box is connected to
an aerial signal or to Internet. If a new software is found
and downloaded successfully, it will be installed at the
next power on.
Note: Do not unplug the power adaptor cord while led
is blinking during the reboot process. If the box fails to
come on after the upgrade, unplug, wait for two minutes
then plug it back in.
Connectivity
Wired Connectivity
To Connect to a Wired Network
• You must have a modem/router connected to an active
broadband connection.
• Connect your PC to your modem/router. This can be a
wired or wireless connection.
• Connect your box to your modem/router via an ethernet
cable. There is a LAN port at the rear (back) of your box.
Broadband ISP connection
LAN (ethernet) cable
LAN input on the rear
side of the Box
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105.
To configure wired settings please refer to the Network/
Internet Settings section in the Settings Menu.
• You might be able to connect your box to your LAN
depending on your network's configuration. In such a
case, use an ethernet cable to connect your box directly
to the network wall outlet.
LAN input on the rear
side of the box
Configuring Wired Device Settings
Network Type
The Network Type can be selected as Wired Device,
Wireless Device or Disabled, in accordance with the active
connection to the box set. Select this as Wired Device if you
are connecting via an ethernet.
Internet Speed Test
Highlight Internet Speed Test and press the OK button.
Set-top box will check the internet connection bandwidth
and display the result when complete.
Advanced Settings
Highlight Advanced Settings and press the OK button.
On the next screen you can change the IP and DNS
settings of the box. Highlight the desired one and press
Left or Right button to change the setting from Automatic
to Manual. Now you can enter the Manual IP and / or
Manual DNS values. Select the related item in the drop
down menu and enter the new values using the numeric
buttons of the remote. Press the OK button to save
settings when complete.

Wireless Connectivity

To Connect to a Wireless Network
The box cannot connect to the networks with a hidden
SSID. To make your modem's SSID visible, you should
change your SSID settings via the modem's software.
To Connect to a wireless LAN, you should perform the
following steps:
• To configure your wireless settings please refer to the
Network/Internet Settings section in the Settings
Menu.
Advanced features
n e t w o r k
wall socket
25