Remote Control; Connection To The Tv - Bush FVPZAPPER100 Instruction Manual

Connections
Bringing it all together

Remote Control

First open the battery cover on the underside of the remote control. Put in both batteries 1.5Volt (RO3/AAA) referring
to the imprinted symbols (+/-) in the battery case and put on the battery cover again. While using the remote control,
direct it towards the front side of the receiver. If the remote control does not work or the chosen function does not
work, the batteries are most probably exhausted and they should be replaced as soon as possible. Please use only
the leak proof batteries. It is best to remove the batteries from the remote unit if you will not be using the remote
control unit for long time.
1. 2.
3.

Connection to the TV

HDMI Connection (recommended): For HD video and audio output you can use the HDMI socket if your TV has
an HDMI input. There is an HDMI socket that supports 4 different resolutions on the rear side of the set-top box. For
best video performance please check the supported resolutions of your TV.
Analog A/V Connection: If you don't want to use the HDMI connection you can use the analog output of your set-
top box to connect it to your TV. You can transfer audio and video after switching the televisions input source to the
related source option.
If you require any technical guidance or find that your set-top box is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
14 Connections