Center Speaker - Sony DVP-NC80V Operating Instructions (DVPNC80V) Operating Instructions Manual

7
Press X/x to select the setting that
matches your TV type.
If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN SCAN
(page 67)
If you have a wide-screen TV or a 4:3
standard TV with a wide-screen mode
• 16:9 (page 67)
8
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your amplifier
(receiver) appears.
Is this player connected to an amplifier
(receiver)? Select the type of jack you
are using.
YES
NO
9
Press X/x to select the type of jack
(if any) you are using to connect to
an amplifier (receiver), then press
ENTER.
If you did not connect an AV amplifier
(receiver), select "NO." Quick Setup is
finished and connections are complete.
If you connected an AV amplifier
(receiver) using just an audio cord, select
"YES: LINE OUTPUT L/R (AUDIO)."
Quick Setup is finished and connections
are complete.
If you connected an AV amplifier
(receiver) using a digital coaxial or
optical cord, select "YES: DIGITAL
OUTPUT." Setup Display for "DOLBY
DIGITAL" appears.
If you connected an AV amplifier
(receiver) using an audio cord, select
"YES : DIGITAL & 5.1CH OUTPUT."
The Setup Display for "DOLBY
DIGITAL" appears.
10
Press X/x to select the type of
Dolby Digital signal you wish to
send to your amplifier (receiver).
If your AV amplifier (receiver) has a
Dolby Digital decoder, select "DOLBY
DIGITAL." Otherwise, select "D-PCM."
24
LINE OUTPUT L/R(AUDIO)
DIGITAL OUTPUT
DIGITAL & 5.1CH OUTPUT
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
11
Press ENTER.
"DTS" is selected.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
12
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
• If your AV amplifier (receiver) has a DTS
decoder, select "DTS." Otherwise,
select "D-PCM."
13
Press ENTER.
When "DIGITAL OUTPUT" is selected
in step 9
• Quick Setup is finished and
connections are complete.
When "DIGITAL & 5.1CH OUTPUT" is
selected in step 9
• The Setup Display for "SPEAKER
SETUP" appears.
14
Press X/x to select the size of the

center speaker.

If no center speaker is connected, select
"NONE" (page 71).
SPEAKER SETUP
SIZE:
DISTANCE:
LEVEL(FRONT):
LEVEL(REAR):
TEST TONE:
FRONT:
CENTER:
REAR:
SUBWOOFER:
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
D-PCM
DOLBY DIGITAL
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
D-PCM
D-PCM
DTS
OFF
LARGE LARGE
SMALL
LARGE
NONE
LARGE
YES