Setting The Digital Output Signal - Sony DVP-NC80V Operating Instructions (DVPNC80V) Operating Instructions Manual

AUDIO FILTER
Selects the digital filter to reduce noise above
22.05 kHz (Sampling frequency (Fs) of the
audio source is 44.1 kHz), 24 kHz (Fs is
48 kHz), or 48 kHz (Fs is above 96 kHz).
SHARP Provides a wide frequency range
and spatial feeling.
SLOW
Provides smooth and warm
sound.
Note
There may be little effect by changing the digital
filter depending on the disc or playback
environment.
DOWNMIX (DVD VIDEO/DVD-VR mode
only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Checking the
audio signal format" (page 45). This function
affects the output of the following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (OPTICAL or COAXIAL)
jack when "DOLBY DIGITAL" and "DTS"
is set to "D-PCM" (page 70).
DOLBY Normally, select this position.
SUR-
Multi-channel audio signals are
ROUND
output to 2 channels for enjoying
surround sounds.
NORMAL
Multi-channel audio signals are
downmixed to 2 channels for use
with your stereo.
DIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jack.
ON
Normally select this position. When
you select "ON," see "Setting the
digital output signal" for further
settings.
OFF
The influence of the digital circuit
upon the analog circuit is minimal.
Note
Super Audio CD audio signals are not output from
a digital jack.
70

Setting the digital output signal

Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 20.
Select "DOLBY DIGITAL," "DTS," and
"48kHz/96kHz PCM" after setting
"DIGITAL OUT" to "ON."
If you connect a component that is
incompatible with the selected audio signal, a
loud noise (or no sound) may be heard from
the speakers, risking damage to your ears or
speakers.
DOLBY DIGITAL (DVD VIDEO/DVD-VR
mode only)
Selects the type of Dolby Digital signal.
D-PCM Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 70).
DOLBY
Select this when the player is
DIGITAL
connected to an audio
component with a built-in
Dolby Digital decoder.
DTS
Selects the type of DTS signals.
D-PCM
Select this when the player is
connected to an audio
component without a built-in
DTS decoder.
DTS
Select this when the player is
connected to an audio
component with a built-in DTS
decoder.