Tcp/Ip Communication Port Control - Kensence FMX Series Operation Manual

output the color space can be YCBCR,RGB; set to DVI the color space only supports
RGB;
5. [x1], [x2], [x] in instructions is the effective range of input or output channel number, if
beyond the scope, it can seen as command input error;
6. "[" and "]" in instructions are non sending characters;
7. The end of each instruction can not be missed, such as "." ", and so on, and must be
punctuation in English input;
8. Pay attention to the Caps Lock.

8.3 TCP/IP communication port control

Through TCP/IP communication port control matrix, its factory default IP address is:
192.168.10.2; gateway: 192.168.0.1 (IP, gateway can be changed), port number: 4001 (no
change). The matrix host can be connected to a single non networked computers, control
through the GUI software, can also access to LAN, realizes multi machine control at same
time, using TCP / IP communication port control matrix need to change the control
computer's IP same as matrix's IP before establishing a connection.
8.3.1Control computer IP changes
First: open the network and sharing center, open "local connection", click "properties" to
enter the interface as shown in figure A:
Fig8.3.1 Computer IP changes