Pronk Technologies SimSlim SL-8 Operator's Manual page 5

3. Waveform Selection Within a Mode
• Some of the SimSlim simulator modes contain multiple waveforms.
• An example of this is ARR MODE 1 which has NSR with PVCs, VTACH, VFIB and
Asystole waveforms.
• These waveforms are listed on the bottom label.
• To change between waveforms within a mode, click the mode button once.
4. Zeroing Invasive Blood Pressures
• Click the mode button once to zero all blood pressures for 15 seconds, then zero monitor within
that 15 seconds. After 15 seconds the blood pressures will return to their prior values. You may
shorten the 15 second wait time to resume IBP simulation mode by pressing the MODE button
once any time after zeroing the monitor.
5. Cardiac Output Readings
• Double click the mode button to select the desired C.O. mode.
• Enter into the monitor the appropriate computational constant determined by referencing the
injectate temperature listed on the CC table on the bottom label of the SimSlim
• Hold the mode button for 2 seconds to start a simulated C.O. injection.
PRc:>NK TEOHNc:>Lc:>C31ES
Revision L 07/18/2017
www.pronktech.com
(800) 541-9802 Page 5