Table of Contents
Advertisement
Troubleshooting Tips
TROUBLESHOOTING TIPS
SYMPTOM
Not calling VTACH or VFIB
I am trying to advance
quickly through the
waveforms, but
sometimes I
accidentally change the
mode
Misshapen or undersized
ECG waveform
Not picking RESP
waveform
No Heart rate on EASI
configured telemetry
Unable to resolve
problem
Services
(Prices subject to change without notice)
SERVICE ITEM NUMBER
Annual SimSlim Calibration
*Pronk Technologies recommends an annual calibration interval.
PRC:,NK TEOHNC:,LC:,GIES
Revision L 07/18/2017
SOLUTION
Some arrhythmia systems will not call VTACH on a straight
jump out of clean NSR. At the start of ARR MODE 1 the NSR
section has some PVCs and runs mixed in. In some cases, it
may be necessary to let the arrhythmia system see some of
these PVCs prior to transitioning into VT ACH.
For rapid single clicking, watch the LED. If you click a second
time while the LED is still on, this will be seen as a double click,
which will change the mode. If you click a second time just after
the LED has gone out, it will be seen as a second single click,
which will advance the waveform.
With Hardware E6 and prior, some monitors will occasionally
have interaction between the IBP and ECG. Unplug IBP to
work around the problem. On E7 hardware, touching the metal
shell of an IBP connector and an ECG snap at the same time can
cause waveform interaction.
Most monitors look for respiration drive across RNLA leads.
Some do not. If RESP waveform is not picking, try swapping
the RL and LL leads. Please keep in mind that RESP is zero
in ARR MODE 1 and ARR MODE 2.
When viewing AVR or V2 lead, change the V lead to V6 snap.
Contact Pronk Technologies' Technical Support at:
(800) 541-9802
DESCRIPTION
Full checkout, adjustment and
calibration certificate
www.pronktech.com
PRICE (USO$)
Call for Pricing
(800) 541-9802
Page 13
Hide quick links:
Advertisement
Table of Contents
