2+1 Channel Surround Hookups - Sony DVP-K350 Operating Instructions Manual

2+1 Channel Surround Hookups

This connection is for listening to the sound through the
left and right speakers of the TV, or speakers connected to
a receiver and the subwoofer. You can enjoy rich bass
frequencies by connecting a subwoofer. Refer to the
instructions supplied with the component to be
connected.
Set "SUBWOOFER" in "SPEAKER SETUP" to "YES" in
the setup display (page 67). Then set "FRONT SPEAKER
SIZE" to "TV" when you use the TV's speakers, or to
"LARGE," "MIDDLE" or "SMALL" when you use the
speakers connected to the receiver.
z
You can enjoy surround sounds even if you connect front
speakers only
You can use 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without using actual
rear speakers (Virtual Enhanced Surround). For details, see page
35.
CD/DVD player
WOOFER
To AUDIO
OUT
(WOOFER)
Subwoofer
(Active type)
INPUT
: Signal flow
12
AUDIO OUT DIGITAL OUT VIDEO OUT
R L PCM/DTS/MPEG/
1 DOLBY DIGITAL
COAXIAL OPTICAL
2
To AUDIO
OUT
To audio input
or
To audio input
Required cords
Audio connecting cord (not supplied) (1)
White (L)
Red (R)
S video cord (not supplied) (1)
Monaural audio cord (not supplied) (1)
One for a subwoofer
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
S VIDEO OUT COMPONENT VIDEO OUT
Y C /B-Y C /R-Y
B R
1 1
2 2
To S VIDEO
OUT
To S VIDEO input
INPUT
VIDEO
S VIDEO
L
AUDIO
R
Receiver (Amplifier)
CD
L
R
Notes
You cannot enjoy a picture with an S video signal if your TV does
not conform to the S video signal. When your TV does not have
an S VIDEO input, connect the component via the VIDEO INPUT
connector using the video connecting cord (not supplied) instead
of the S video cord. For details, see page 8.
Refer to the instructions supplied with your TV.
White (L)
Red (R)
To mains
TV