Table of Contents
Advertisement
Port
LED
Caution: If any FXS module is setup, you should make
power on. During the above processes, an ESD wrist strap
is needed. Once power is on, you must not attempt to
install or take down the board. If all modules are installed, the modules
from 1 to 4 access the uppermost port and the rest modules are grouped
by the same manner, in another word, every four modules correspond to a
port in hardware then a port is divided into four channels by a splitter.
You have to insert the PSTN lines into FXO ports and extension
telephone lines into FXS ports. After hard ware setup appropriately, it is
time to install software.
OpenVox Communication Co. LTD.
A1200P on DAHDI User Manual
Power supply
connection
PCI slot
Figure 4 Hardware setup
13
URL: www.openvox.cn
Advertisement
Table of Contents
