Sony DAV-HDX500 Operating Instructions Manual page 85

Connect the calibration mic to the A.CAL
MIC jack on the front panel, and set it up at
the ear level using a tripod, etc. (not
supplied). The front of each speaker should
face the calibration mic, and there should be
no obstruction between the speakers and the
calibration mic. Be quiet during the
measurement.
AUDIO IN / A.CAL MIC
Calibration mic
5
Press X/x to select [YES], then press
.
Calibration starts.
Measuring. Please wait a moment.
Note
• Avoid being in the measurement area and
making noise during the measurement (about
one minute), to avoid measurement failure.
During the measurement, test signals are output
from the speakers.
• The environment of the room in which the
system is installed may affect measurements.
• If an error message appears, follow the message,
then select [YES].
An error message appears when:
– the headphones are connected.
– the calibration mic is not connected.
– front speakers are not correctly connected.
– surround speakers are not correctly
connected.
– front and surround speakers are not correctly
connected.
– subwoofer is not connected.
6
Press C/X/x/c to select [YES] or [NO],
then press .
x The measurement is OK.
Disconnect the calibration mic, then select
[YES]. The result is implemented.
Measurement complete.
FRONT L :
FRONT R :
CENTER :
SUBWOOFER :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
"YES".
YES
x The measurement is not OK.
Follow the message, then select [YES] to
retry.
Measurement failure.
Check speaker connection.
Retry?
YES
NO
Tip
• You can check the distance between the listening
position and each speaker. See page 92.
16ft 4.87m 0.0dB
16ft 4.87m 0.0dB
16ft 4.87m + 1.0dB
16ft 4.87m + 4.0dB
10ft 3.04m - 2.0dB
10ft 3.04m - 2.0dB
NO
continued
85
US