Sony BDV-EF200 Operating Instructions Manual page 55

Symptom
There is no sound from the TV
via the HDMI (OUT) jack when
using the Audio Return Channel
function.
The system does not output
sound correctly when connected
to a set-top box.
Severe hum or noise is heard.
The sound loses stereo effect
when you play a CD.
Distortion occurs in the sound of
a connected component.
Tuner
Symptom
Radio stations cannot be tuned
in.
Playback
Symptom
The disc does not play.
File names are not displayed
correctly.
A disc does not start playing
from the beginning.
Playback does not start from the
resume point where you last
stopped playing.
The language for the soundtrack/
subtitle or angles cannot be
changed.
Bonus contents or other data that
are contained in a BD-ROM
cannot be played.
Problems and solutions
• Set [Control for HDMI] in [HDMI Settings] of [System Settings] to [On]
(page 49). Also, set [Audio Return Channel] in [HDMI Settings] of [System
Settings] to [Auto] (page 49).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that an HDMI cable is connected to a jack on your TV that is
compatible with the Audio Return Channel function.
• Set [Audio Return Channel] in [HDMI Settings] of [System Settings] to [Off]
(page 49).
• Move your TV away from the audio components.
• Clean the disc.
• Select stereo sound by pressing
• Reduce the input level for the connected component by setting [Attenuate -
AUDIO] (page 47).
Problems and solutions
• Check that the antenna (aerial) is connected securely. Adjust the antenna
(aerial) or connect an external antenna (aerial) if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic
tuning). Use manual tuning.
Problems and solutions
• The region code on the BD/DVD does not match the system.
• Moisture has condensed inside the unit and may cause damage to the lenses.
Remove the disc and leave the unit turned on for about half an hour.
• The system cannot play a recorded disc that is not correctly finalized (page 58).
• The system can only display ISO 8859-1-compliant character formats. Other
character formats may be displayed differently.
• Depending on the writing software used, the input characters may be displayed
differently.
• Resume play has been selected. Press OPTIONS and select [Play from start],
then press .
• The resume point may be cleared from memory depending on the disc when
– you open the disc tray.
– you disconnect the USB device.
– you play other content.
– you turn off the unit.
• Try using the BD's or DVD's menu.
• Multi-lingual tracks/subtitles or multi-angles are not recorded on the BD or
DVD being played.
• Try the following: 1 Remove the disc. 2 Turn the system off. 3 Remove and
reconnect the USB device (page 26). 4 Turn the system on. 5 Insert the BD-
ROM with BONUSVIEW/BD-LIVE.
(page 32).
55
GB