Compatibility Of The Communication Module Hardware With Profibus-Dp Firmware Versions And Mapping Files - Siemens SIPROTEC 7SA522 Manual

PROFIBUS RS485 (PSE module)
P-Slave
AME
up to HW revision 3
PROFIBUS fibre-optical, double loop (PSO module)
Ch1
P-Slave
up to HW revision 3
Figure 1-1 HW revisions of the communication modules, labelling of the mounting brackets
1.1.3 Compatibility of the communication module hardware with PROFIBUS-DP
firmware versions and mapping files
Hardware and
firmware
SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
RS232-LWL
RS232 RS485
P-Master
General details about the assembly of communication modules as well as the setting
of the terminating resistors on the PSE modules you find in the SIPROTEC4 System
Manual (ref. to page 3).
Please note the following listed compatibility between the hardware revisions of the
communication modules and the PROFIBUS-DP firmware versions:
Hardware revision
up to HW revision 3
from HW revision 4
Table 1-1 Hardware revisions and firmware versions
The PROFIBUS-DP firmware for communication modules from HW revision 4 is:
• function compatible with firmware versions for modules up to HW revision 3
(i.e. contains all there contained functionalities),
• offers additional functionalities, e.g.:
• display of module-specific information at the device (ref. to chap. 1.2),
• OLM V3 compatibility mode with fibre-optical modules (ref to chap. 2.1.2).
Profibus
AME
from HW revision 4
Ch2
Ch1
from HW revision 4
PROFIBUS Communication modules
RS232-LWL
RS232 RS485
Ch2
Profibus
Firmware version to be used
up to PROFIBUS-DP firmware V03
from PROFIBUS-DP firmware V04
13