Siemens SIPROTEC 7SA522 Manual page 5

Additional Support
Training courses
Target audience
SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
with PROFIBUS communication module from HW revision 4 and
• PROFIBUS-DP firmware version 04.00.06 or higher at use of
• Display of module specific information (ref. to chap. 1.2),
• OLM V3 mode of the PROFIBUS-DP module (ref. to chap. 2.1.2),
• PROFIBUS-DP firmware version 04.01.01 or higher at use of
• PROFIBUS time synchronization messages with local time correction value
(ref. to chap. 4.4.2).
For device parameterization have to be used:
• DIGSI 4.21 considering the preconditions explained in chapter 4.1.3,
• DIGSI 4.30 or higher,
• DIGSI 4.40 or higher at use of
• Transformer tap change commands/Transformer tap position indications
(ref. to chap 3.7 and 3.8),
• PROFIBUS-DP standard mappings 3-1 to 3-n
(n = device type dependent number of standard mappings).
For questions regarding SIPROTEC4 devices, please contact your Siemens repre-
sentative.
Individual course offerings may be found in our Training Catalog and questions can be
directed to our Training Centre. Please contact your Siemens representative.
Protection engineers, commissioning engineers, personnel concerned with adjust-
ment, checking and service of selective protective equipment, automatic and control
facilities and personnel of electrical facilities and power plants.
Preview
5