Siemens SIPROTEC 7SA522 Manual page 65

List box
"Mapping file"
Edit area
"Module-specific
settings"
SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
If no mapping file is currently assigned to the SIPROTEC device then the following
entries are available in the list box "Mapping file":
Selection
<none>
PROFIBUS-DP standard mapping 3-1
...
PROFIBUS-DP standard mapping 3-n
The following entries can be selected at an already existing mapping file assignment:
Selection
<none>
<see module-specific settings>
PROFIBUS-DP standard mapping 3-1
...
PROFIBUS-DP standard mapping 3-n
If the mapping file assignment was changed for a SIPROTEC device, then this is in
general connected with a change of the routing of the SIPROTEC objects to the
system interface.
Please, check after choice of a new mapping file the allocations to "Destination system
interface" or "Source system interface" in the DIGSI configuration matrix.
Please, edit only the numbers in the rows which do not start with "//" and note the
semicolons at the end of the line.
Editing anything else in the "Module-specific settings" may cause an error when clos-
ing the Interface Settings device dialog window.
PROFIBUS-DP - Parameterization in DIGSI
Meaning
No mapping file is assigned to the device.
Selection of a mapping file 3-1 to 3-n (n = device
type dependent number of standard mappings).
Meaning
No mapping file is assigned to the device.
This selection indicates the currently to the device
assigned mapping file with the changes of bus
specific parameters already carried out in the edit
area "Module-specific settings".
Number and version of the mapping file have to be
taken from the first line in the edit area "Module-
specific settings".
(New) Selection of a mapping file 3-1 to 3-n
(n = device type dependent number of standard
mappings). All bus specific parameters are reset to
default values.
65