Advertisement
5.4.4 Installation of the push rod (pos. 22), the plunger (pos. 20), the bearing (pos. 64)
and the rotary plate (pos. 21)
After installing the balance scale bar, guide the push rod (pos. 22) through the bore hole in
the bottom of the spindle operating area and place it on the balance scale bar (push rod
centres itself!).
Guide the plunger (pos. 20) on top of the push rod into the bore hole so that the push rod
presses - centred - into the plunger bore hole on the mounted pan (pos. 23).
Place the axial deep groove ball bearing (pos. 64) on the mounted plunger.
Place the rotary plate (pos. 21) with pressed pan (pos. 41) on the axial deep groove ball
bearing. Ensure that the table can rotate.
Warning:
If you upgrade to additional option 3 (test force display), the push rod supplied will have
two sections.
The full scope of delivery includes a factory-mounted push rod.
In the middle of the two-section push rod there is a load cell. Guide the red plug of this
load cell through the lower rear bore hole (with thread) at the VKA-110 and connect it to
the control cabinet before you install the balance scale bar. Now carefully screw in the
grey-coloured cable guide (grey stopper) from the inside of the VKA housing. Pull out the
two-section push rod (with the load cell pre-mounted by HANSA Press) from the bottom
through the bore hole in the spindle operating area. You can now install the balance scale
bar (see 5.4.3.1).
Caution! Do not route the cable between cutting bolt (pos. 25) and cutter holder (pos. 26).
After installing the balance scale bar, you can now guide the two-section push rod through
the bore hole in the spindle operating area and place it on the balance scale bar.
32
Advertisement
