Panasonic NA-FS95G3 Service Manual page 11

5. Test Mode
Number of times
Check
the "Water level"
Procedure
button is pressed
3
4
5
6
Check Contents
• Adjust the water
amount against
E
laundry amount
detection
• Set to initial mode
M for tension of the
Belt
• Indicate the error
G message of the
last time.
• Indicate the
H
operation times.
Lamp Illumination
Condition
• Press the "WASH" button to adjust L0 (initial
mode) to L1 (1‐rank higher water level).
• Press "START/PAUSE" button to confirm.
• In case to change PCB or remove the V‐belt,
set the V‐belt tension to initial mode for using
below procedure.
• The initial display will be indicated "b0" after
that, press "START / PAUSE" button once, it
shall be listened click sound six times to set
properly.
• "Digit lights" shall be indicated "E" initially,
Press "WASH" button to show the last error,
and press the wash button again to return to
initial mode.
• If any error message occurred in the past, "H"
or "U" and some number shall be indicated
alternately.
If no error message occurred, the light
indicates "00".
• "Digit lights" shall be indicated "C" initially,
Press "WASH" button to change "Indication of
digit" of operation times.
Press once: Digit "Thousand & Hundred"
Press twice: Digit "Ten & One"
‐10‐
Operation Condition