5. Test Mode
1. Set the power switch to "off".
2. Press and hold both the "Water lever" and "Wash" buttons with one hand.
3. Press the power switch to "on".
4. Release your fingers from the buttons and power switch which you pressed in steps (2) and (3) .
(Check A can be carried out in this state with your fingers released)
5. Within three seconds press the "Water lever " button to set the desirer check procedure.
(Carry out checks B, C, E, M, G and H)
Check A
Check H
Number of times
Check
the "Water level"
Procedure
button is pressed
0
1
2
(2)
Check B
Check G
Check Contents
• Cycle end buzzer
A
• Timer indicator
• Auto power off
• Washing
B
operation
• Spin operation
C
• Lid/SF switch
Check C
Check M
Check E
Lamp Illumination
Condition
• When the end buzzer sounds three times, the
lamps will simultaneously flash on and off in
the remaining time display, and the power will
automatically be switched off immediately
after operation is finished.
• Even if there is no water in the tub, the
washing operation will continue for 10
minutes.
• Press the "Rinse" button once FV‐1 operates,
and press twice to operate FV‐2, press 3 time
hot water valve (FV‐3) operates.
• If the PCB fault occurred, an error indication
"H05" will display.
• The spinning operation will continue for 6
minutes.
• Check the lid & SF switch operation, while
opening lid
1) "74L" lights up ... Lid switch working
2) "86L" lights up ... SF switch working
‐9‐
(1)
Operation Condition