Auto On / Off Times; Auto Source Select - Q Acoustics Media 3 Owner's Manual

8.5. Auto On / Off Times

a. HDMI
• ON time is determined by the CEC response time of your TV; it can take between 0-10s.
• OFF time is determined by the CEC response time of your TV; it can take between 0-5s.
b. Optical
• ON time is immediate once the red Optical light from your source comes on.
• OFF time is immediate once the red Optical light from your source turns off.
Note:
Some televisions continue their optical output when the TV is in STANDBY. The Unit will not AUTO
OFF under these circumstances and the STANDBY control must be used.
c. Bluetooth
• ON time is determined by the AVRCP response time of your Bluetooth device; once your device
is connected, and you press Play it can take between 1-5s.
• OFF time is determined by the AVRCP response time of your Bluetooth device. Once you turn
Bluetooth off, or disconnect your device it can take between 1-3s.
d. Line In 1 / 2
• ON time commences when the signal level becomes audible. It can take between 1-3s.
• OFF time commences when the signal level is not audible and will take 20 minutes.
Note:
If the user places the Unit in STANDBY while a source is still playing, the AUTO ON function will be
disabled until the source is stopped. This will prevent the Unit from unwanted AUTO ON.
For Line In 1 / 2 the signal must be at a not audible level for 20 minutes before the Unit AUTO ON
will function.
8.6.

Auto Source Select

The ASS follows a priority list for connected audio sources. A connected HDMI source that starts
to play has the highest priority, followed by Optical, then Bluetooth and finally Analogue 1 and 2.
Note:
The ASS can be overridden at any time by a simple manual SOURCE SELECTION from the user.
HDMI
Optical
Bluetooth
Line in 1
Line in 2
Standby
INPUT
PRIORITY
15