R Healthcare Dash Series Technical Information Manual page 39

Part number – request information from customer services
6" x Width
9" x Width
12" x Width
Where used
8TRL, 9TRL, AP100, SP100, ACCESS, ACCENT, DASH LITE, DASH LIFE
Tools and Techniques
The following tool will be required;
Pozi screw driver
Mallet – soft head
Service and maintenance
At each service check for:

Any damaged or contaminated canvas must be replaced – cross contamination could occur, or there may be
an effect on stability.
Damaged or worn, components need to be replaced, if assembled in pairs Remploy Healthcare
recommends replace both assemblies, for continuity of wheelchair in use.
Method
10. Canvas height and width

Select height of extended back rest canvas, 6, 9, or 12 inch to suit assessment needs.

Width of canvas will vary dependent upon the width of the wheelchair.
11. Back rest canvas screws

Remove 4 off back rest canvas screws – discard.
12. Bobbins for retaining back rest extension.

Fit 2 off 12 mm bobbins to each push handle tube, using the screws holes vacated by the previous
canvas screws.

Tighten each bobbin using the 5mm x 20 mm Pozi head screw, approx torque of 7NM.
13. Fit Back Rest Extension

Side the 2 back rest extensions over the bobbins, ensuring the push handle tube aligns firmly in the
key way

Fit plastic end caps to each back rest extension tube at the top.
Ensure there is no rattle and movement in the assembled back rest assembly when fitted to wheelchair.
Spares and Options should only be fitted by a trained and competent person
www.rhealthcare.co.uk
Post code S41 8NJ
Weight excluding packaging: 1.0. Kgs max. Per wheelchair
R Healthcare Technical Information Manual - Dash
Fitting Instruction – Back Rest Extension
Page 39 March 2007 Revision B