Table of Contents
Advertisement
Capacities:
5.5 Honda: 0.95 US Gal (3.6 Lts, 0.79 Imp Gal)
9.0 Honda : 1.59 US Gal (6.0 Lts, 1.32 Imp Gal)
3.
Engine oil:
Use an SAE 10W30 multi-viscosity oil meeting the
American Petroleum Institute (API) classification
of SF OR SG for normal operating temperatures.
Consult the engine manual for unusual operating
conditions. Do not mix oil types or viscosities.
Crankcase Capacity:
5.5 hp: 0.53 US Qts (0.5 Lts, 0.44 Imp Qts)
9.0 hp: 1.16 US Qts (1.1 Lts, 1.94 Imp Qts)
4.
Storing Lubricants and Fluids
Your machine can operate at top efficiency only if
clean lubricants are used. Use clean containers to
handle all fluids. Store them in an area protected
from dust, moisture and other contaminants.
5.1.2
GREASING
Refer to section 5.1.1 for recommended grease. Use the
Maintenance Checklist provided to keep a record of all
scheduled maintenance.
5.1.3
SERVICING INTERVALS
Daily or 8 Hours
1.
Check engine fluid levels. Top as required.
a.
Check engine oil level. Top up as required.
b.
Check fuel level. Add as required.
Clutch Linkage
Fig. 20 DRIVE BELT TENSION
Daily or 8 Hours (cont'd)
3.
Grease the drum assembly bear-
ings (2 locations).
Fig. 22 CLUTCH LINKAGE SHAFT (TYPICAL)
Fig. 19 ENGINE FLUID LEVELS
2.
Check the drive belt tension with the clutch
engaged.
WARNING
Machine is shown with engine hood open
for illustrative purposes only. Never oper-
ate with hood open.
Machine
Fig. 21 DRUM ASSEMBLY BEARINGS
4.
Grease the clutch linkage shaft
in the power compartment
location).
32
b
a
(1
Advertisement
Table of Contents
