Intellitech Commands; Pcl Language; Pcl Command Structure - IntelliTech IntelliBar Mi Series Programmer's Manual

IntelliTech International, Inc.

IntelliTech Commands

There are frequent references to Hewlett Packard's (HP) PCL Technical Reference
Manual (TRM). This document can be found on HP's website listed in the Referenced
Documents above. IntelliTech provides unique commands not within the command set
found in the HP's PCL TRM. No command defined within this document supersedes or
negates any commands found within the PCL TRM. This does not imply that all
commands defined within the PCL TRM are implemented by the IntelliTech Mi Series
Barcode Label Printers. Many commands found within the PCL TRM are irrelevant within
the context of the IntelliTech Mi Series Barcode Label Printer. Examples of these are
commands for selecting discrete pages sizes such as Letter, Legal, A4, and Executive.
Features such as duplexing and stapling do not currently exist in IntelliTech Mi Series
Barcode Printers and these commands, if found within the data stream, are silently
ignored without error.

PCL Language

PCL Command Structure

General Information
As per Hewlett Packard's specification on the syntax of escape sequences, there are two
forms of PCL escape sequences: two-character escape sequences and parameterized
escape sequences.
Two character escape sequences have the following form:
<ESC>X
"X" is a character that defines the operation to be performed. Two examples of two-
character escape sequences are <ESC>E and <ESC>9. The first example resets the
printer to default conditions and the second resets the left and right margins to their
default value. The value of "X" may be any character within the range 0x30 – 0x7E.
Parameterized escape sequences have the following form:
<ESC>X y z1 [+|-]#[.#] z2 [+|-]#[.#] z3 ... [+|-]#[.#] Zn[data]
The following characters y, #, zi and data may be optional. The parameterized character
X is within the range of 0x21 – 0x2F. The group character "y" is within the range of 0x60
– 0x7E. Group characters specify the type of control being performed.
Table 1: Parameterized Character <ESC> X...
Character (X)
0x21
0x22
0x23
0x24
Symbol
! Reserved for debug firmware
" Not Used
# Not Used
$ IntelliBar Mi Series Barcode Parameter
Purpose
3 Thermal Printer Programmer's Guide
Programmer's Guide | 1