IntelliTech IntelliBar Mi Series Programmer's Manual page 37

IntelliTech International, Inc.
Variable
7
HORIZONTALOFFSET
7
VERTICALOFFSET
7
ORIENTATION
7
RASTERMODE
1
FONTNUMBER
1
PITCH
1
PTSIZE
1
SYMSET
7
PRINTTRUNCATION
PRINTONGAP
7
DARKNESS
4, 7
SHARPNESS
4
VERTICALADJ
4
HORIZONTALADJ
Description
Shifts the print area of the
logical page to the left or right on
the physical page in decipoints
Shifts the print area of the
logical page up or down on the
physical page in decipoints
Controls the orientation of the
logical page on the physical
page
This controls how overlapping
images are placed on the paper
This is the typeface number the
printer uses if none is specified
in the command stream
This specifies the default
character pitch in characters per
inch. The default font must be a
fixed pitch font.
This specifies the default point
size of the default font. The
default font must be scalable for
this to be effective.
This specifies the default
symbol set. The symbol set
must be resident in the printer.
This clips the print image at the
MARK or GAP. If the
PAPERTOFTYPE is "NONE"
then clip at PAPERLENGTH.
Sets the printer to print on gap/
mark or not
This allows for the adjustment of
the darkness of the printed
image due to printhead thermal
variations.
This allows for the adjustment of
the leading edge darkness of
the printed image due to
printhead thermal variations.
This allows for the vertical
adjustment of the start of image
relative to the horizontal leading
label edge due to mechanical
variations.
This allows for the horizontal
adjustment of the image relative
to the printhead center.
31
Programmer's Guide | 1
Range
0 - 7200
0 - 2880
PORTRAIT, LANDSCAPE,
RPORTRAIT,
RLANDSCAPE
TRANSPARENT,
OPAQUE
0 – 512
0.44 - 99.99
4.00 - 999.75
PJL sym set name3
OFF, ON
OFF, ON
± 20
± 10
± 100
± 100
Thermal Printer Programmer's Guide
Default
0
0
PORTRAIT
TRANSPAREN
T
23
10.00
12.00
PC8
ON
OFF
0
0
0
0