Pjl Head Cleaning Procedure/Command - IntelliTech IntelliBar Mi Series Programmer's Manual

1 | Programmer's Guide
Parameter
RIBBONFRONT
RIBBONBACK
REWIND
SELFTEST
HEADCLEANMODE
GPIOSELFTEST
GPIOWRITE
GPIOREAD
PRINTSETTINGS
PRINTINFO
PRINTNETWORK
PRINTSERIAL
PRINTGPIO
PRINTFONTS
PRINT10
PRINT20
PRINT50
PRINTQL
SETDATETIME
SETTIMEZONE

PJL Head Cleaning Procedure/Command

Prior to performing print head cleaning the head clean mode must be entered as follows:
Thermal Printer Programmer's Guide
Description
Performs test of front
(take-up) ribbon spindle
assembly
Performs test of back
(supply) ribbon spindle
assembly
Performs test of rewinder
assembly
Initialize self-test mode
Initialize head clean mode
Performs GPIO wrap test
Test of GPIO input pins
Test of GPIO output pins
Print the settings report
Print system info report
Print network report
Print serial report
Print Applicator (GPIO)
report
Print fonts report
Print internal 10% pattern
Print internal 20% pattern
Print internal 50% pattern
Print internal quality label
Set data and time
Set time zone
Value
N/A
N/A
N/A
0 for disable, 1 for
enable, 2 for reset
counters
0 for disable, 1 for
enable
N/A
Integer representing
on/off state of output
pins
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Quantity to print
Quantity to print
Quantity to print
Quantity to print
String "HHHH-MM-DD
hh:mm:ss"
String, i.e. "EST+5" for
Eastern Standard
Time
24
IntelliTech International, Inc.
Notes
Must be in self test
mode (See below)
Must be in self test
mode (See below)
Must be in self test
mode (See below)
Must be in self test
mode (See below)
Must be in self test
mode (See below)