IntelliTech IntelliBar Mi Series Programmer's Manual page 25

IntelliTech International, Inc.
Command
Deletes files or empty directories from the
1
FSDELETE
printer file system
Initializes (formats) the mass storage system
1
FSINIT
COMMENT Adds a line of information as comments
DINQUIRE Obtain the default value of a specified PJL
environment variable
DEFAULT Sets the user default environment value for the
specified environment variable. These values
are shown on front panel equipped printers.
This command should only be used with the
default configuration setting of the printer and
NOT with each print job. See the SET
command below for setting up a specific print
job.
ECHO Prompts the printer to return a specified
message to the host computer
ENTER Selected a printer language for processing the
current job
INITIALIZE Resets the PJL current environment and user
default environment variables to the factory
default values
INFO Requests a specified category of printer
information
INQUIRE Requests the current value for a specified PJL
environment variable
RESET Resets current PJL variables to user default
values
SET Sets a current environment variable to a
specified value for the duration of a PJL job
USTATUS Allows printer to send unsolicited status
messages
USTATUSOFF Turns off all unsolicited status
JOB Informs printer of the start of a print job
EOJ Tells the printer the print job is complete
Caution: Exercise caution when issuing these PJL Commands. They cannot be undone.
1
Use the PJL DISKLOCK variable to prevent unauthorized file system access. Refer to
the PJL Technical Reference document for more information.
Description
19
Programmer's Guide | 1
Modifications
Restrictions added (See below)
Clears user flash file system and
reboots (See below)
N/A
N/A
N/A
N/A
N/A
N/A
More categories added (See below)
N/A
Also writes flash if changes to user
default values
N/A
N/A
N/A
Added additional security option (See
below)
Also writes flash if changes to user
default values
Thermal Printer Programmer's Guide