Advertisement
Available languages
Available languages
T245 Changing Cartridges
Save time and change cartridges safely without switching the station off.
1. Removing
2. Inserting
Place the handle in the
Place the handle on top of
extractor and pull to
the new cartridge and press
remove the cartridge.
down slightly.
Important
*
It is essential to insert the cartridges as far as the mark for a proper connection.
Mark
Compatible cartridges
The T245 handle works with C245 cartridges. Find the model that best suits your soldering needs
in www.jbctools.com
ø 1
ø 1,5
Round
Chisel
Round bent
8
3. Fixing
C
D
B
A
Use the holes for fixing the
cartridge* as follows:
A. For straight C210.
B. For curved C210.
C. For curved C245.
D. For straight C245.
ø 3,5
B
A
A
Bevel
Special models
DR560 Changing Tips
This operation should be done while the tip is hot, not below 250°C, so that any tin left inside is in
molten state.
1. Removing
Unscrew the tip using the spanner
supplied.
2. Inserting
Fit the new tip and tighten with the
spanner to make sure it is air tight.
Compatible Tips
The DR560 works with C560 tips. Find the model that best suits your soldering needs in www.jbctools.com
Here are some C560 tips in real size (mm):
C560-001
ØA=1,4 ØB=0,6 Ømax. pin=0,4
C560-001
C560-014
ØA=2,5 ØB=0,8 Ømax. pin=0,6
C560-014
ØA=3,2 ØB=1,3 Ømax. pin=1,1
C560-004
C560-004
w w w.jbctools.com
250ºC minimum
A ø
B ø
C560-002
ØA=1,8 ØB=0,8 Ømax. pin=0,6
C560-002
C560-003
ØA=2,7 ØB=1 Ømax. pin=0,8
C560-003
ØA=5 ØB=1,3 Ømax. pin=1,1
C560-009
C560-009
9
Advertisement
