Honeywell EXCEL 5000 Product Data page 12

DISTRIBUTED I/O – PRODUCT DATA
Digital Output Module XFL524B
XFL524B
K1 K2
~230 V
N
35 27
28
1 2 3
PE 0
230 V
M
Fig. 14. XFL524B terminals / wiring examples
The digital output module has six isolated change-over con-
tacts which can be connected to actuators or other switchable
devices.
The unit plugs into the XSL514 Terminal Block and can be
inserted and removed without disturbing other units on the
bus. Terminals 1 through 18 are switched according to Fig.
14. Six LEDs are located on top of the module. The module
address is set using the rotary HEX switch (in the case of
applications prior to CARE 4.0).
EN0B-0090GE51 R0316
K3 K4 K5
L1
19
20
 Six isolated change-over contacts
 Max. voltage U
 Max. current I
max
 LED per channel
OFF: LED off
ON: LED illuminated (yellow)
 Green power LED (L1) and red L
 Cycle time 1 sec with CPU
 Dimensions (WxLxH): 47x97x70 mm
Beginning with Excel 500 controller firmware version 2.04.00,
the online point attribute Normally Open / Normally Closed
(NO/NC) defines the relation between the physical state (relay
on/off) and its logical status. See Table 11.
nviRequest
input nviValue
nv1
SNVT_obj_request SNVT_switch
NV 1
K6
nviRequest
input
nc1 UCPTSensorConfig
SNVT_obj_request
NV 1
This output NV appears only once for the node.
1
Fig. 15. L
ON
NOTE: The relays can be used to switch signals with up to
230 Vac and 2 A. All outputs from a single module
must be of the same kind. It is not allowed to mix
high-voltage (e.g. 230 Vac) and low-voltage (e.g.
24 Vac) signals.
12
= 230 Vac per output
max
= 2 A per output
W
ON ORKS
Open Loop Actuator
Object Type #3
Mandatory
Network
Variables
Optional
input
nv3
Network
NV 1
Variables
input
nv1
NV 1
User-Defined
Network
Variables
input
nv1
NV 1
Optional
Configuration
Properties
M Object for each digital output
ARK
status LED (L2)
nviRequest
nvoFeedback
SNVT_obj_request SNVT_switch
1
nviRequest
nvoDiagnose
SNVT_count
SNVT_obj_request
nviRequest
nvoManCnt
SNVT_obj_request SNVT_count