Table of Contents
Advertisement
Installing the Batteries
The Model H10C meter is packaged with 4 "AAA" alkaline batteries required for
operation. To insert the batteries into the meter, follow the procedure outlined below.
1.
Use a screw driver to remove the two screw and battery cover to
expose the battery compartment. (Figure 1)
2.
Note the polarity and insert the batteries into the battery
compartment correctly.
3.
Replace the battery cover and make sure to secure the two screws
for the water-tight feature.
[Note: Press the "On/Off" key to turn the unit on. If the unit is
running then you can press the "On/Off" key to turn the unit off. The
unit will automatically turn off after 20 minutes of no key activity.]
3
Figure 1
Advertisement
Table of Contents
