Table of Contents
Advertisement
Vandal-resistant entrance panel
Installer manual
Access control settings
The configurations of this menu are only possible if the phonic (speaker) module is not
configured physically
ACCESS CONTROL SETTINGS
Central address (A/B)
Reader address (C)
Operating mode (M)
Central address
(A/B)
Reader address (C)
Operating mode (M) M=0 - The address book, the calling code and the door lock codes are
Menu management
00
1
0
Address of the access control central unit that manages the reader
(keypad built in the entrance panel, (keypad built in the entrance panel;
the A/B address corresponds to the address of the C0/C1 control unit)
Reader address (keypad built in the entrance panel) in the ACC system.
managed by the entrance panel and can be modified locally from the
menu or from the configuration software.
M=2 - The address book, the calling code and the door lock codes are
managed by the access control system and must not be modified locally.
Note: do not confuse this configurator with the other M referred to the
address of the riser column.
Full
The settings and the address book can be almost fully modified, with
the following exceptions:
•
If the address book is not empty, the call code digits and the lock
code digits cannot be changed.
•
If M = 2, lock codes cannot be changed
Limited (can be set only with TiMonoblockEntrancePanel):
a) The following options can be only remotely changed by the access
control central:
•
Password
•
Language
•
Number of call code digits
•
Number of lock code digits
•
Riser base address
b) The following menu options are not allowed in the installer menu
because the acccess control central takes care of the address boook:
•
New contact
•
Modify contact
•
Delete contact
•
Delete address book
28
Hide quick links:
Advertisement
Table of Contents
