Use Programmer - Julabo DYNEO DD Series Operating Instructions Manual

Pos: 39 /Technische Dokumentation/Flash CORIO/D yneo/Programmgeber @ 1\mod_1516618670206_18.do cx @ 12588 @ 2333 @ 1

15.3 Use programmer

Using programmer, setpoint temperature sequences
can be quickly and easily programmed. Such a
temperature sequence is referred to as profile. A
profile is compiled of individual steps. The steps are
defined using duration (t:) and gradient (°/t) and
target temperature.
The target temperature is the setpoint temperature,
which is reached after completing a step. Based on
the time and temperature difference in a step, the
programmer calculates a temperature ramp (1).
Caution:
If the time specified is too short, the actual
temperature cannot reach the setpoint temperature.
For this case, the programmer can be used to edit a
profile.
If the time for a step is defined as 00:00:00, the
setpoint temperature "jumps" (2) to the target
temperature.
Only after the specified temperature is reached
(±0.2 °C), the profile is continued with the next step.
Eight profiles with up to 60 steps each can be stored.
The Standard or Gradient settings can be mixed
in a profile.
48
Setpoint = green
Actual value = red