Nozzle Table - Baumatic BMEH3GSS Instructions For Use And Installation

NOZZLE TABLE

BURNER
Nominal Rate (kW)
Ø INJECTOR (mm)
G30/G31 28..30/37mbar
Ø BY-PASS (mm)
G30/G31 28..30/37mbar
Important warnings
Cookware
A SR R
1,00 1,75 3,00
0,50 0,65 0,85
0,27 0,31 0,42
The gas burners are fitted a candle as flame failure device. If the burner flame is

extinguished accidentally or unintentionally, e.g. when some liquid boils over or
when there is draught in the room, gas supply is automatically cut off, thus
preventing the gas from being emitted into the room.
Gas burner cover should always be placed on the burner crown very carefully. Make sure

the slots on the burner crown are never obstructed.
1 Burner crown cover
2 Burner crown with the support for the burner cover
3 Candle flame failure device
4 Ignition candle
5 Nozzle
Correctly selected cookware will enable optimum cooking time and gas consumption. Pan

diameter is the most important parameter.
Use pans which are the right size for each burner. Do not use small pans on large burners.

The flame should not touch the sides of the pan.
For combustion, the gas also needs air. If a pan is too large, air supply to the burner is

insufficient; as a result, combustion effect is lesser.
Always place the pan right over the burner, not to one side. Otherwise it could tip over. Do

not place large pans on the burners near the control knobs. These may be damaged by
the very high temperatures.
Never use two burners or heat sources to heat one single pan. Do not use grill pans,

earthenware casserole dishes, etc. for a long period of time on maximum power especially
on crystal glass gas hobs.
Pans should be placed on the hob carefully. Do not strike the hob and do not place

excessive weight on it.
Place the pans on the pan supports, never directly on the burner. Make sure that the pan

supports and burner caps are correctly positioned before using the appliance.
Stainless steel working table can burnish when subjected to excessive heat. Therefore we

don't recommend prolonged cooking with soapstone, earthenware pans or cast iron
plates. Avoid the use of aluminum foil to protect the working table during cooking
operation.
Do not use cast iron plates or griddles for cooking or heating food on the burners (check
the sizes of pot allowed for each kind of burner) specially on cristall glass gas hobs
Cooktop should not be used as a worktop. Sharp objects can cause scratches.

Preparing food in thin aluminum of plastic containers on hot cooking zones is not allowed.

Do not place any plastic objects or aluminum foil on the cooktop.
To get the best from the burners, use flat-bottomed pots with a diameter suited to the

burner being used.
For smaller diameter pots and pans (coffee and tea pots, etc.), the power of the burner

being used has to be regulated in order to ensure that the flame laps the bottom of the pot
without spilling over.
Do not use pots with concave or convex bottoms.

BURNER MIN-MAX PAN DIAMETER
A
SR
R
MW
DC4M
DC5D
DC5D
MW DC4M
EXT.
3,30 4,00
0,90 1,00 1,00
0,55 0,60 FIXE
12 - 18 cm
18 - 22 cm
22 - 24 cm
22 - 26 cm
22 - 26 cm
22 - 26 cm
9
INT.
5,00
0,44
0,27