ACN DigitalTalk Express Quick Installation Manual

Please follow these basic instructions to install your base and cordless phone. Once you are done, refer to the DigitalTalk® Express support
Review Enclosed Items
Handset Base Unit
2 AC Adapters Ethernet Cable
1
STEP
Setting Up the Base Unit
1. Plug the handset cord into the handset and into the side of the base unit.
2. Plug the AC Adapter into the outlet.
3. Plug the AC Adapter into the back of the base firmly.
4. Connect your Ethernet cable to the
LAN port.
5. Connect the other end of the Ethernet
cable into an empty port in your Internet router.
FYI:
If you only have an Ethernet port on your router or modem, you can
connect your computer to the network through the base unit. Connect
one end of your Ethernet cable to the port labeled PC (silver) on the
base unit. Connect the other end to the Ethernet port of your computer.
Once you have connected the base,
the startup process will begin. You
will notice that the status indicator
on the base unit is flashing. This
indicates that the base unit is being
configured. You will see a series of
colors on the status indicator.
When your phone is ready to use
the status light will be solid green,
which signals that your system is
configured. This process may take
up to 5 minutes. Until that time, do
not unplug, disconnect or change any settings on your phone.
Congratulations! You have successfully connected your new DigitalTalk® Express phone system.
NEXT STEP: Visit the DigitalTalk® Express support section of myacn.com for the online tutorial to show you all the features and functionalities of your phones.
Manage your DigitalTalk® Express account online in the My Account section of myacncanada.ca. This provides you with the ability to view and
Quick Installation Guide
Congratulations on the purchase of your new ACN DigitalTalk® Express Phone System!
section of myacncanada.ca for an online step-by-step tutorial on your new DigitalTalk® Express System and its functions.
Handset Charger
Handset Cord
2 AAA Batteries
PC LAN
update your payment information, as well as additional support information.
Cordless Handset
A D D I T I O N A L I T E M S
Belt Clip Index Sticker
2
STEP
Setting Up the Handset
1. Take off the handset cover and install the 2 AAA batteries.
2. Replace the handset cover.
3. Plug the AC Adapter into an outlet.
4. Connect the AC Adapter to the handset charger.
Please note: Make sure to repeat this process for any additional handsets.
3
STEP
Registering Your Handset to the Base
Please follow these steps for EACH handset.
1. From the handset press Menu using the center of the joystick.
2. Then press #130 on the keypad of the handset.
3. On the base unit, press and hold the ALL button for 4 seconds. The
status indicator will then turn red.
4. When the handset starts ringing, press the ALL button on the base unit
to stop.
5. Press OK on the handset and hold until a long beep sounds.
6. When the handset has been registered
successfully , will change to
FYI:
To access your voice mail:
Press Voice Mail on your base unit and enter your
4-digit password (initially set to 1234). View the
Quick Reference Guide for more ways to access
your voice mail.
.
©ACN CANADA 2018_ CA_DTExpressQIG_PRDT_P_011718