Table of Contents
Advertisement
+
Manual MSX
7 Mechanical Installation
In case you receive an individually packed MSX
service, unpack the module in ESD protected area only.
CAUTION – Possible damage by ESD!
The power stage consists of sensitive electronic components that can be
destroyed by electrostatic discharge voltages.
- Always store and transport single modules in ESD protective
packaging.
- Always handle the components in compliance with the ESD protection
measures.
-
CAUTION – Possible damage!
i
The MSX
supplied with >120 V
-
Before integrating or switching power stage modules always make sure that the stepper
motor controller of the SLS is shut down and the power supplies are disconnected.
WARNING – Serious injury from electric shock!
During electrical installation cables, connectors, etc. can be live.
- Before starting wiring, make sure that none of the power supplies is
connected to the primary side of the mains supply. Isolate the power
supplies from the mains or remove the appropriate fuses.
-
All modules must be inserted and screwed into the controller`s or
SLS's housing. If necessary, unoccupied module slots must be covered
with the supplied blank front plates. Never operate the equipment when
open.
-
Do not plug or unplug the power stages while powered.
-
Do not plug or unplug the connectors while powered.
-
If the equipment was energised, wait 3 minutes after power off to allow
the capacitors to discharge and ensure that there are no residual
charges on cables, connectors and boards.
Now you can start with the electrical installation.
MA 2128-A004 EN
No liability is accepted for any consequences resulting from
improper handling or non-ESD-friendly packaging.
+
is designed for a maximum supply voltage of 120 V
the card might be damaged.
DC
Make sure that a mains unit with no more than 120 V
damage.
+
as an expansion module or after repair or
28
. If it is
DC
to prevent
DC
Advertisement
Table of Contents
