Conair Thermolater vacuTrac User Manual page 43

7
Press the RUN button to save the passcode.
N N
The control will display "Pr OFF" to prompt you to
remove power to the unit.
IMPORTANT: If RUN is not pressed, the new
passcode will not be saved.
8
Turn off power to the unit.
the main power supply.
9
Open the electrical
enclosure.
10
Set dip switch 3 to OFF.
Close the electrical enclosure and restore
11
power to the unit.
A passcode now is required to change system parameters.
Disabling Passcode Protection
To disable passcode
protection and allow
universal access to
system parameters:
1
Follow Steps 1
through 5
in the
previous section
on enabling pass-
code protection.
Hold down the M M setpoint adjustment button
2
to select "OFF" as the new passcode.
Follow steps 7 through 11 in the previous section.
3
UGH015/0100
Disconnect and lock out
8 7 6 5 4 3 2 1
Thermolator TW-1 and TW-2
E
NABLING AND
D
ISABLING
P
ASSCODE
P
ROTECTION
3-11
I
NSTALLATION