Unpacking The Boxes - Conair Thermolater vacuTrac User Manual

U
NPACKING THE
B
OXES
3-2
I
NSTALLATION
Thermolator TW models come fully assembled. If they were
specified at the time of the order, the optional purge valve or
motorized cooling valve is factory-installed.
Remote control cord
(TW-2 only)
Thermolator
1
Carefully remove the Thermolator
nents from their shipping containers, and set upright.
Remove all packing material,
2
tape, and plastic. Check inside the electrical enclosure
and behind the side panels for accessories or hardware
that may have been placed there for shipping.
3 Carefully inspect all components
damage occurred during shipping, and that you have all
the necessary hardware. If damage is found, notify the
freight company immediately.
Take a moment to record serial numbers
4
specifications in the blanks provided on the back of the
User Guide's title page. The information will be helpful if
you ever need service or parts.
5 You are now ready to begin installation.
Complete the preparation steps on the next page.
Thermolator TW-1 and TW-2
Motorized cooling valve
(optional)
Compressed air mold purge
(optional)
and compo-
protective paper,
to make sure no
UGH015/0100
and