Lamtec LT 2 Assembly And Commissioning Manual page 41

4 Technical Description
4.12.3 Calculation of the concentration of CO
measured O
4.12.4 Load-dependent, fuel-specific limit curves (optional extra) Type 6 57 R 0920
4.12.5 Integrated PID/O
4.12.6 Output of internal load via analogue output (only in conjunction with ETAMATIC/FMS/VMS)
Type 6 57 R 1124
value and the max. CO
2
The calculation takes place according to the following formula:
CO = CO max – 21 % -O
(
2 2
The calculation is based on the following maximum CO
% with dry exhaust gas
Fuel oil EL
Natural gas H
Fuel oil S
Natural gas L
CO max can be preset individually via the parameters 846, 862, 878 and 894.
2
Output via analogue output 3:
0...20% CO2 = 4...20mA
The load rating (burner load) or another measured variable is activated via analogue
input 4 or the LAMTEC SYSTEM BUS. Instead of fixed limit values, fuel-specific
curves with two to maximum 18 interpolation points can be entered.
Limit curves (factory setting) parameterised to undershoot, or alternatively
two fuels with four limit curves each/two limit values per fuel
controller Type 6 57R1120
2
See separate manual DLT4002.
Forwarding of internal load via current input or LAMTEC SYSTEM BUS.
0...1000digits load
, calculated for the specific fuel on the basis of the
2
value Type 6 57 R 0910
2
/ 21%)
2
15.4 vol. %
12.0 vol. %
15.9 vol. %
11.7 vol. %
0/4...20mA
39
contents at λ = 1 = O
2 2
= 0 vol.