Magnetic Autocontrol MPH 112 Operating Instructions Manual page 25

Assembly and installation
58175005EN 01/2009 MPH-112
Version: 00
Insert the glass wing carefully between the clamping strips without
twisting it.
IMPORTANT NOTE!
To position the glass wing, adjust the dimension between the hous-
ing and the glass wing edge to 160 mm for MPH Standard, and to
190 mm for MPH Wide. Tighten the clamping screws (2) progres-
sively and alternately to a torque of ca. 20 Nm.
Due to manufacturing tolerances, there may be differences; it is
therefore recommended that you release the drive unit from its
blocked state, move it to the open position, and then check that the
glass wing end is flush with the housing. If it is not, repeat the ad-
justment so as to correct the difference you have observed.
4
Fig. 4-10 View of central housing showing slot cover
Engage the cover strip (4) with the carrier and push the latter up-
wards as far as it will go, so that the cylindrical pin contacts the
edge towards the panel. When tightening the nuts to secure it, take
care that the carrier is in contact with the glass wing edge. Unblock
the drive unit.
Before fitting the end housing to the central housing, continue with
Section 5.
Page 25/96