Connecting A Satellite Receiver (Sat) And Vcr - Sony KP-57XBR10W Operating Instructions Manual

Connecting a Satellite
Receiver (SAT) and VCR
1
Connect the cable from the satellite antenna to
the satellite receiver.
2
Attach the coaxial cable from the incoming
cable connection or antenna to VHF/UHF IN
on the VCR.
3
Using a coaxial cable, connect VHF/UHF
OUT on the VCR to VHF/UHF on the
projection TV.
4
Using AUDIO and S VIDEO* cables, connect
AUDIO and S VIDEO OUT on the satellite
receiver to AUDIO and S VIDEO IN on the
VCR.
5
Using AUDIO and S VIDEO* cables, connect
AUDIO and S VIDEO OUT on the VCR to
AUDIO and S VIDEO IN on the projection TV
(White-AUDIO Left, Red-AUDIO Right).
* If your VCR or satellite receiver is not equipped
with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
Note:
• To view input from the satellite receiver or VCR,
select the video input which your satellite receiver
or VCR is connected to by pressing TV/VIDEO on
the remote control.
(Rear of projection TV)
CONTROL S
VIDEO 4
IN OUT
IN
VIDEO 1 VIDEO 3
S VIDEO
VIDEO
P
L
(MONO)
AUDIO
P
R
COMPONENT
VIDEO
S
AUDIO-L
VIDEO
AUDIO-R
5
VMC-810S/820S (not supplied)
YC-15V/30V (not supplied)
Disconnect all power sources before making any connections.
AUX
IN OUT
VIDEO 5 (DTV) SELECT
SATELLITE IN
HD VD
LINE OUT
VHF/UHF
1
Y Y/G
VIDEO
Satellite
L
(MONO)
P /B
B B
antenna
L
cable
AUDIO
P /R R
R R
R
AUDIO
VMC-810S/820S
(not supplied)
LINE
LINE
OUT
3
Satellite
VHF/UHF
receiver
AUDIO R AUDIO L VIDEO
S VIDEO IN
OUT
YC-15V/30V
(not
supplied)
4
VCR
S VIDEO
AUDIO R AUDIO L VIDEO
IN VHF/UHF
OUT
IN
Cable/
Antenna
2
15