Connecting A Vcr And Projection Tv To A Cable Box - Sony KP-57XBR10W Operating Instructions Manual

Connecting a VCR and
Projection TV to a Cable Box
1
Connect the single (input) jack of the splitter to
the incoming cable connection, and connect
the other two (output) jacks (using the coaxial
cable) to IN on the cable box and VHF/UHF
on the projection TV.
2
Using a coaxial cable, connect OUT on the
cable box to IN on the VCR.
3
Using AUDIO and S VIDEO* cables, connect
AUDIO and S VIDEO OUT on the VCR to
AUDIO and S VIDEO IN on the projection TV
(White-AUDIO Left, Red-AUDIO Right).
* If your VCR is not equipped with S VIDEO, use
a VIDEO cable (yellow) instead of the S VIDEO
cable.
Note:
• To view scrambled channels through the cable box,
select the video input which the cable box is
connected to by pressing TV/VIDEO.
(Rear of projection TV)
CONTROL S
VIDEO 4
IN OUT
IN
VIDEO 1 VIDEO 3
S VIDEO
Y
VIDEO
P
L
(MONO)
AUDIO
P
R
COMPONENT
VIDEO
S VIDEO AUDIO-L
AUDIO-R
VMC-810S/820S
(not supplied)
YC-15V/30V (not supplied)
Disconnect all power sources before making any connections.
AUX
IN OUT
SELECT
VIDEO 5 (DTV)
HD VD
VHF/UHF
Y/G
VIDEO
L
P /B (MONO)
B B
L
Coaxial cable
AUDIO
R P R /R R
R
AUDIO
VCR
S VIDEO
AUDIO R AUDIO L VIDEO
LINE
IN VHF/UHF
OUT
LINE
OUT IN
3
Cable box
2
1
Cable/
Antenna
OUT
IN
Splitter
(not supplied)
11