Installing and Connecting the Projection TV
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
Connect the satellite antenna cable to the satellite receiver's
SATELLITE IN jack.
Connect the CATV cable to the VCR's VHF/UHF IN jack.
Using a coaxial cable, connect the VCR's OUT jack to the projection
TV's VHF/UHF jack.
Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO
Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
YC-15V/30V (not supplied)
Be sure your VCR's video input is set correctly. Consult your VCR's
operating manual for instructions.
Use TV/VIDEO to select
- VIDEO 1 to watch satellite TV or the VCR (your VCR must be turned
- VHF/UHF to watch cable TV.
If your VCR or satellite receiver is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO cable.
Rear of projection TV