Safety Information And Installation Requirements; General Safety Information; Injury Precautions - Caen A 1732 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. A1732-A1832 High Voltage Boards

3. Safety information and installation requirements

3.1

General safety information

This section contains the fundamental safety rules for the installation and operation of the
boards. Read thoroughly this section before starting any procedure of installation or
operation of the product.
3.1.1

Injury Precautions

Review the following precautions to avoid injury and prevent damage to this product or
any products connected to it. To avoid potential hazards, use the product only as
specified. Only qualified personnel should perform service procedures.
Avoid Electric Overload.
To avoid electric shock or fire hazard, do not apply a voltage to a load that is outside the
range specified for that load.
Avoid Electric Shock.
To avoid injury or loss of life, do not connect or disconnect cables while they are
connected to a voltage source.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
Do Not Operate in Wet/Damp Conditions.
To avoid electric shock, do not operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
To avoid injury or fire hazard, do not operate this product in an explosive atmosphere.
Do Not Operate With Suspected Failures.
If you suspect there is damage to this product, have it inspected by qualified service
personnel.
NPO:
00101/00:17XXx.MUTx/05
Filename:
A1732B-A1832B_REV5.DOC
Revision date: Revision:
02/05/2005 5
Number of pages:
20
Page:
12