Advertisement
Cleaning the TOSHIBA Label Printer for Business Partner Systems
Model #B-EV4D-GS24
Cleaning the TOSHIBA Label Printer
Complete the following procedures in the order given. This
document supersedes any other cleaning instructions. These
instructions are specific for the TOSHIBA Label Printer Model # B-
EV4D-GS24 on RSS systems.
Step 1 — Power OFF the TOSHIBA Label Printer
1. If the printer was just used, allow the printer/print head to cool before
performing any maintenance as the print head may become hot immediately
after printing.
IMPORTANT NOTE: If the Status indicator light on the top of the printer is
slowly flashing, alternating red and green, wait to allow the printer/print head
to cool down before performing any maintenance.
2. Be sure to power OFF (see Figure 2) the TOSHIBA Label Printer before
performing any maintenance. Even if your RSS System is powered off, the
label printer has its own power supply and must be powered off as well. Make
sure that the indicator light (see Figure 1) is no longer lit to confirm the printer
has been powered off.
November 2016
Always follow instructions to ensure the protection of personnel, devices, and data
Figure 1: Status Light
Figure 2: Power switch
LIMITED RIGHTS NOTICE
V2.1
Status
Page 3 of 16
Advertisement
