Safety Instructions; Section Cut From The Countertop - Smeg Dolce Stil Novo Series Manual

Testing
At the end of installation, carry out a brief
inspection test. If the hob fails to operate,
after checking that you have carried out the
instructions correctly, unplug the appliance
and contact Technical Support.

5.2 Safety instructions

Heat production during appliance
operation
Risk of fire
• Check that the carcase material is heat
resistant.
• Check that the carcase has the required
openings.
• Do not obstruct the ventilation grille in
front of the product during mounting.
Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
The minimum clearance between a
ventilation hood and the cooking surface
must be at least the distance indicated in the
ventilation hood installation instructions.
The minimum clearances must also be
respected for the edges of the hob on the
back as indicated in the mounting
illustrations.
Installation

5.3 Section cut from the countertop

The following operation requires
building and/or carpentry work
and must therefore be carried out
by a competent tradesman.
Installation can be carried out on
various materials such as masonry,
metal, solid wood or plastic
laminated wood as long as they
are heat resistant (>90°C).
Create an opening with the dimensions
shown in the figure in the countertop of the
piece of furniture.
Dimensions for flush mounting
L (mm)
380
600
900
A (mm)
min 50
X (mm)
310
560
880
B (mm) C (mm) D (mm)
min 460 min 750 20 - 60
Y (mm)
490
490
490
E (mm)
min 50
55