Setting Brightness; Setting Screen Shut-Off; Setting Day/Night Illumination - Webasto UniControl Operating Instructions Manual

Press the control knob in order to choose the temperature
X X
unit.
This setting is taken over without confirmation.
9.7

Setting brightness

Depending on the installation, the screen brightness adapts using the vehicle
signal.
3
The menu element "Settings" has been chosen.
Turn the control knob in order to choose menu element
X X
"Brightness".
Press the control knob in order to confirm selection.
X X
Turn the control knob in order to choose the desired value.
X X
The adjustment value flashes
Press the control knob in order to confirm selection.
X X
9.8 Setting screen timeout
3
The menu element "Settings" has been chosen.
Turn the control knob in order to choose menu element
X X
"Screen timeout".
Press the control knob in order to confirm selection.
X X
Turn the control knob in order to choose the desired time or
X X
"Auto" mode.
Press the control knob in order to confirm selection.
X X
After selecting „Auto" mode the screen does not
switch off during active heating/ventilation. If no
heater is active then while setting "Auto" the screen
switches off after 10 seconds.
9.9

Setting day/night illumination

In the case of the screen illumination you can select between the day and
night illumination. If „Off" option is selected then the general setting of bright-
ness level is activated with no distinction between the day and night.
Settings
Units
Settings
Brightness
Settings
Brightness
Settings
Screen timeout
Settings
Day/Night
23