ALDI Workzone Titanium Xfinity Series Instruction Manual page 97

26
Troubleshooting
Fault
The Battery pack gets
warm when charging.
Undiagnosable Fault.
The machine does
not start up when
operating the on/off
switch.
Cutting depth is less
than is set.
Blade spins or slips
Blade does not cut a
straight line.
Blade kicks back
when beginning a
cut.
AFTER SALES SUPPORT
1300 889 028 (toll free)
Cause
It's a result of the stepping
down of the chemical
reactions inside the
batteries during the
charging process.
The tool needs to be
repaired.
Low battery.
Defective motor.
Sawdust accumulated at
the rear of the base.
Blade is not tightly
engaged with the spindle.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough.
26
Remedy
This is normal.
Return the tool to a
service centre for repair
or contact Customer
Service.
Charge the battery.
Contact Customer
Service.
Shake out sawdust.
Consider connecting
a vacuum for dust
collection.
Re-assemble the blade as
described in ASSEMBLY
section.
Mount a new, sharp
blade on the saw.
Check that blade is
properly mounted.
Use a parallel guide.
Allow the saw blade to
reach full speed prior to
beginning a cut in the
material.
e-mail:
info.aldi@positecgroup.com
MODEL No.:
CSC165XA.9 • 2323 • 05/2019