ALDI Workzone Titanium Xfinity Series Instruction Manual page 90

guard lever (12), tilt back the lower blade guard (13) and hold it
firmly in this position. Remove the saw blade (19).(See Fig.B1,B2)
Mounting the saw blade
WARNING: Always ensure that the saw is switched off and the
battery pack (16) is removed before making any adjustments.
Clean the saw blade (19) inner flange (18), outer flange (20) and the
blade bolt (21). Using the lower guard lever (12), tilt back the lower
blade guard (13) and hold it firmly in this position. Place the saw
blade (19) onto the inner flange (18). Ensuring that the direction of
the cutting teeth on the saw blade match the direction of the blade
rotation indicator (25), place the blade over the outer flange (20)
then insert the blade bolt (21). Press in the spindle lock button (4) to
lock the spindle (27), then use the supplied hex key (24) to tighten
the blade bolt (21) in an anti-clockwise direction with 1/4 turn more
than finger tight.
NOTE: Take care that the mounting positions of the inner
flange and outer flange are correct.( See Fig.B3)
NOTE: When mounting: Ensure that the cutting direction of
the teeth (direction of arrow on saw blade) and the blade
rotation indicator (25) on the blade guard match.
8.2 Adjusting the cutting depth (See Fig. C)
WARNING: Always ensure that the saw is switched off and the
battery pack (16) is removed before making any adjustments.
Turn the cutting depth lock knob (23) in an anti-clockwise direction,
and raise the saw body away from the base plate (11). Set the depth
of cut using the cutting depth scale (22) and then turn the cutting
depth lock knob (23) in a clockwise direction to lock. Always add
3mm to your depth of cut so that the blade can cut through the
material.
AFTER SALES SUPPORT
1300 889 028 (toll free)
19
e-mail:
info.aldi@positecgroup.com
MODEL No.:
CSC165XA.9 • 2323 • 05/2019
19