ALDI Workzone Titanium Xfinity Series Instruction Manual page 41

22
8.11 Overload Protection
When overloaded, the motor comes to a stop. Relieve the load on
the machine immediately and allow cooling for approx. 30 seconds
at the highest no-load speed.
8.12 Temperature cut out
If the drill/driver is constantly overloaded, or the drill/driver is used
constantly at maximum rating in high ambient conditions, the battery
cells may overheat causing the battery pack to shut down.
When this occurs you will need to allow the battery cells to cool.
NOTE: The drill/driver will not restart until the battery pack has cooled.
To reduce the temperature of the cells remove the battery pack from
the drill/driver and place the battery pack in a free air environment, out
of direct sunlight or any other heat source.
DO NOT force cool the pack in any way. Do not place in refrigerators or
freezers.When the battery pack has cooled down it can again be used
to operate the drill/driver, as long as the load or the conditions causing
the original excessive temperature has been corrected.
8.13 Low voltage cut out
The battery pack used on this tool is fitted with a low voltage cut out
feature within the circuitry.The low voltage cut out feature operates
when the voltage drops below a preset value. This feature automatically
stops the drill/driver from operating (similar to that of the overload
condition). When this condition occurs you will need to either insert
another battery into the drill/driver or recharge the existing battery.The
low voltage cut out feature has been added to maximise the life of the
battery cells in the battery. When this occurs, recharge the battery pack
by following the battery charging section in this manual.
NOTE: Attempting to restart the tool without either recharging the
battery or installing another battery (with charge) will lead to drill/
driver restarting and then stopping again, after only a few seconds of
operation.
AFTER SALES SUPPORT
22
e-mail:
info.aldi@positecgroup.com
1300 889 028 (toll free)
MODEL No.:
CDT218XA.9 • 2323 • 05/2019