Scan Bar Codes; About Scanning Configuration Bar Codes - Honeywell CK65 Series User Manual

Scan Bar Codes

By default, the computer imager is enabled for scanning. It supports
omni-directional (360°) bar code scanning and an aiming beam is provided to help
assist with targeting bar codes.
Before you start scanning bar codes, go into Settings > Honeywell Settings >
Scanning > Internal Scanner and modify the scan profile to enable only the bar
code symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
1. Point the scanner window at the bar code. For optimum performance, avoid
2. Press and hold any Scan button (i.e., right, left, or front).
3. Center the aiming beam over the bar code. Make sure the entire bar code is
4. Release the Scan button when the computer beeps, and the Scan Status LED
Note: Not all bar code symbologies are enabled by default. If a bar code does not scan, the
correct symbology may not be enabled.

About Scanning Configuration Bar Codes

After completing the out-of-box set up process, Provisioning mode is
automatically turned Off. Scanning a bar code to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you turn On
(enable) Provisioning mode in the Settings app.
To learn more
CK65 Mobile Computer
reflections by scanning the bar code at a slight angle.
inside the illumination frame.
briefly turns on. The bar code information is entered into the application in use.
About Provisioning Mode see page 63.
41