Part No. 890034 T h a n k Yo u f o r S e l e c t i n g The Powerful KD or TKD TERMITE SELF PROPELLED VACUUM CHIPPER Operator Owner's Manual KD511SP, TKD511SP Specifications KD511SP ENGINE:H.P. 5.5 (4.1kW) ENGINE:TYPE B&S DIAMOND I/C...
IN THE INTEREST OF SAFETY BEFORE STARTING ENGINE, READ AND UNDERSTAND THE “ENTIRE OPERATOR'S MANUAL & ENGINE MANUAL.” THIS SYMBOL MEANS WARNING OR CAUTION. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY. WARNING: to the State of California to cause cancer, birth defects or other reproductive harm. WARNING: DO NOT 1.
Read all safety and operating instructions before assembling or starting this unit. PUT OIL IN ENGINE BEFORE STARTING Your Billy Goat is shipped from the factory in one carton, completely assembled except for the upper handle, debris bag, and bag quick disconnect.
Label Do Not Fill While Away Engine Is Hot Item 29 Part Item 63 Part No.400268 No.400424 Label Danger Chipper For Wood Only Item 48 Part No. 890152 (TKD MODELS ONLY) DANGER Label Danger Flying Material Item 62 Part No.810736...
(see fig 2.). When feeding forked branches, squeeze forks together and feed into chipper entrance (DO NOT overload). If forks are too large, use a pair of loppers to trim forks down to size. A lopper...
Page 6
OPERATION continued (fig. 2) Note: Dry wood is harder to chip than green wood. 16.5 MULCH Wood chips made from branches in your own yard make excel- lent mulch. A thick blanket of wood chips around plants and flowers to keeps weeds out and moisture in. COMPOST 16.6 Vacuumed leaves, grass and other organic material from your own...
Page 7
This can prevent any remaining wood from jamming in the chipper when machine is turned off. Do not leave tamper on the ground, store tamper in the chipper hopper. Tamper Storage Position 16.9 PROPULSION This vacuum is self-propelled.
If gap is more than 0.080"(2.03mm), remove one or more shim washers as needed to obtain correct gap (see fig. 6 & fig. 7). The chipper will function at up to a maximum of 0.125"(3.18mm) gap. INCORRECT Blade Form No.
IMPELLER REMOVAL 17.1 18. If chipper blade properly clears anvil surface, proceed to step . If not, return to (step 14) and add or subtract shim washers as needed to obtain a correct gap. 19. Reinstall engine and impeller onto housing in reverse order of removal.
Before Requesting Service Review These Suggestions Possible Cause Please fill in the WARRANTY CARD and send the upper part to Billy Goat. The WARRANTY terms are stated on the lower part which remains with the user. Whenever a Billy Goat Machine is faulty due to a defect in material...