Summary of Contents for Billy Goat THE TERMITE TKD502SP
Page 1
The P werful werful werful TKD werful TKD TERMITE TERMITE TERMITE V V V V V A A A A A CUUM CHIPPER CUUM CHIPPER CUUM CHIPPER CUUM CHIPPER CUUM CHIPPER Operator Owner's Man Operator Owner's Man ual Operator Owner's Man...
Page 2
5 5 5 5 5 I N I N I N I N I N THE INTEREST OF SAFETY THE INTEREST OF SAFETY THE INTEREST OF SAFETY THE INTEREST OF SAFETY THE INTEREST OF SAFETY BEFORE STA R BEFORE ST BEFORE ST BEFORE ST BEFORE ST...
PUT OIL IN ENGINE BEFORE STARTING. Your Billy Goat is shipped from the factory in one carton, completely assembled except for the debris bag, upper handle, bag quick disconnect, tamper and bag support assembly.
Page 4
Item 29 Part Item 63 Part No.400268 No.400424 OIL CHAIN EVERY 10 HOURS Label Oil Chain Label Danger Chipper For Wood Item No. 45 Only Item 48 Part No. 890152 Part No. 830502 Label Warning Guards Item 100 Part No.900327 Label Danger Flying Material Item 62 Part No.810736...
(see fig 2.). When feeding forked branches, squeeze forks together and feed into chipper entrance (DO NOT overload). If forks are too large, use a pair of loppers to trim forks down to size. A lopper storage bracket is provided on every unit (loppers are not included).
Page 6
OPERATION continued Note: Dry wood is harder to (fig. 2) chip than green wood. MULCH 1 6 . 1 6 . 1 6 . 1 6 .9 9 9 9 9 1 6 . Wood chips made from branches in your own yard make excel- lent mulch.
Page 7
1 6 . Before turning machine off, use the Tamper to slowly push remaining pieces of wood through the chipper. This can prevent any remaining wood from jamming in the chipper when machine is turned off. Tamper Storage Position. Do not leave tamper on the ground, store tamper in the chipper hopper.
If gap is more than 0.080"(2.03mm), remove one or more shim washers as needed to obtain correct gap (see fig. 6 & fig. 7). The chipper will function at up to a maximum of 0.125"(3.18mm) gap. Page 8 of 12...
Page 9
1 7 . 1 1 7 . 1 1 7 . 1 19. If chipper blade properly clears anvil surface, proceed to step 20. If not, return to (step 14) and add or subtract shim washers as needed to obtain a correct gap.
Page 10
Part No. 890207 Page 10 of 12 PARTS DRAWING TKD502SP TKD502SP TKD502SP TKD502SP TKD502SP Form No. F021795E...
Page 12
Please fill in the WARRANTY CARD and send the upper part to Billy Goat. The WARRANTY terms are stated on the lower part which remains with the user.
Need help?
Do you have a question about the THE TERMITE TKD502SP and is the answer not in the manual?
Questions and answers